Asterisk - The Open Source Telephony Project GIT-master-2de1a68
hep.conf
;
; res_hep Module configuration for Asterisk
;

;
; Note that this configuration file is consumed by res_hep, which is responsible
; for the HEPv3 protocol manipulation and managing the connection to the Homer
; capture server. Additional modules provide specific messages to be sent to
; the Homer server:
;  - res_hep_pjsip: Send SIP messages transmitted/received by the PJSIP stack
;  - res_hep_rtcp: Send RTCP information (all channels)
;

; All settings are currently set in the general section.
[general]
enabled = no                       ; Enable/disable forwarding of packets to a
                                   ; HEP server. Default is "yes".
capture_address = 192.168.1.1:9061 ; The address of the HEP capture server.
capture_password = foo             ; If specified, the authorization password
                                   ; for the HEP server. If not specified, no
                                   ; authorization password will be sent.
capture_id = 1234                  ; A unique integer identifier for this
                                   ; server. This ID will be embedded sent
                                   ; with each packet from this server.
;capture_name = asterisk           ; A unique string identifier for this
                                   ; server. This ID will be embedded sent
                                   ; with each packet from this server.
uuid_type = call-id                ; Specify the preferred source for the Homer
                                   ; correlation UUID. Valid options are:
                                   ; - 'call-id' for the PJSIP
                                   ; - 'channel' for the Asterisk channel name
                                   ; Note: If 'call-id' is specified but the
                                   ; channel is not PJSIP then the Asterisk
                                   ; channel name will be used instead.